Page 1 of 2
M6 x 28 bolt flange
Posted: 19 Mar 2016, 08:43
by SMUDGER
Does anybody know were I can get 14 of these today?
Sent from my E6853 using Tapatalk
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 08:58
by lee
Phone a few bolt stockists.
J r webster used to be good.
Sent from my iPhone using Tapatalk
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 09:18
by SMUDGER
Phoned a few can get normal bolts from m6 x 30 upwards I'm thinking to get these and try and get 4mm washers but thinking they may leak it's for a oil sump as ones I have are like cheese
Sent from my E6853 using Tapatalk
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 09:27
by Baldrick
Try Quasar industrial fasteners in Guide Bridge 339 4445.
Or Brian Popes in Stockport 480 8322. I use these for work and both have decent stocks of all sorts of bolts.
If you're going down the bolt and washer route, use a fibre washer not a steel one, wouldn't recommend it as a permanent fix but it'll keep you going until you can get the proper ones.
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 09:28
by Bradders
Try bradbin and Rudd ltd Wigan mate
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 09:35
by SMUDGER
Bradders wrote:Try bradbin and Rudd ltd Wigan mate
I rode to Bradbin n rudd Bolton this morning as I normal use them but typical shut
Sent from my E6853 using Tapatalk
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 09:44
by Bradders
Wigan is open till 12 I think pal
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 10:23
by SMUDGER
Bradders wrote:Wigan is open till 12 I think pal
Don't Do m6
Sent from my E6853 using Tapatalk
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 18:20
by Cabernet
SMUDGER wrote:Phoned a few can get normal bolts from m6 x 30 upwards I'm thinking to get these and try and get 4mm washers but thinking they may leak it's for a oil sump as ones I have are like cheese
Sent from my E6853 using Tapatalk
File?
Re: M6 x 28 bolt flange
Posted: 19 Mar 2016, 18:22
by SMUDGER
I ended up using m6 stainless steel 2 mm washer and blue loctite and instant gasket seems no leak so far been 3 hours
Sent from my E6853 using Tapatalk